VTRAN - TetraMAX Interoperability Flow
Joint Solution
The interoperability flow between Synopsys' TetraMAX and Source III's vtran with optional test interfaces allow for quick and easy translation of ATPG-generated test vector data to many popular device test program formats, as well as simulation testbench formats. Translations support signal timing and scan data mapping. In addition to this flow for translating TetraMAX WGL & STIL files to test programs, vtran's new Read-Back canned readers provide for a way to verify the test programs directly be translating them back to a Verilog or VHDL testbench for re-simulation prior to loading on a tester.
 |
Intermediate Vector files produced by TetraMAX
Vtran is directed by the command file to read WGL/STIL file and map to desired target format.
Resulting vector file for Tester (Credence, Teradyne, Agilent, ...) or simulation testbench (Verilog or VHDL) |
vtran is a Registered Trademark of Source III, Inc.
Translating TetraMAX Vector Files Using VTRAN
For a typical TetraMAX run, the result is a large WGL or STIL file often containing one or more scan chains and potentially several timing sets. These files may contain thousands, or millions, of vectors with many scan chain data load/unload operations. Translating these vector files into a test program for one of the popular device testers can be a formidable task. Vtran has been developed to specifically deal with this problem and makes the translation process very simple and straightforward.
When creating a WGL file under TetraMAX, the following parameter settings are recommended if vtran is to be used to translate the file to one of the supported tester (or testbench) formats:
set wgl -bidi_map -x -x
set wgl -bidi_map z- z-
set wgl -bidi_map 0x 0x
set wgl -bidi_map 1x 1x
set wgl -bidi_map xx xx
set wgl -bidi_map z0 z0
set wgl -bidi_map z1 z1
set wgl -bidi_map zx zx
set wgl -bidi_map zz zz
set wgl -chain_list shift
set wgl -group_bidis
set wgl -inversion_reference master
set wgl -last_scan
set wgl -nomacro
set wgl -nopad
set wgl -pre_measured
set wgl -scan_map dash
These settings are applicable to TetraMAX version 2.02 and later. They result in a WGL file that is consistent with the WGL syntax specification, which vtran requires. Also, refer to the On-Line Help facility of TetraMAX concerning vtran settings.
For information and examples of vtran command files that can be used to translate WGL and STIL files produced by TetraMAX to various testers and simulation testbenches, please also see the Application Notes page.
